Setting up a windows 7/8 laptop/pc – Actiontec SBWD100A, SBT100U User Manual User Manual
Page 8
6
Connecting to ScreenBeam
3.
Plug one end of the HDMI cable into the HDMI port on the back panel of
the Receiver.
4.
Plug the other end into an HDMI port on the HDTV monitor.
5.
Set your HDTV monitor to display content from the HDMI port (HDMI 1,
HDMI 2, etc.) used in step 4.
The Receiver is now connected to the HDTV monitor. To connect it to either a
compatible Windows 7/8 laptop/PC, Wi-Fi Miracast device, or laptop with Intel
WiDi 3.5 or later, refer to one of the following sections of this chapter.
Setting Up a Windows 7/8 Laptop/PC
If your Windows 7/8 laptop/PC does not have Miracast or WiDi enabled, you must
load the ScreenBeam Wireless Display software onto the laptop, connect the USB
Transmitter, and then pair the Display Receiver to the USB Transmitter. Make sure
you have the following items handy:
s
ScreenBeam USB Transmitter
s
ScreenBeam Wireless Display software CD
s
A compatible laptop/PC running Windows 7 or 8