Actiontec WCB3000N Installation Guide - Manual

READ FIRST! Find the Coaxial Outlet near your Router/
Gateway. If there is already a coaxial cable plugged into the
outlet, connect the ECB2500C MoCA Network Adapter as displayed
in Figure A. If there is NOT, follow the diagram in Figure B.
Step
4
Place the WCB3000N Wireless Network Extender in an
area where your Wi-Fi signal is spotty (where Internet signal does
not reach or drops). You will need a Coaxial Outlet nearby.
Step
1
Connect the Coaxial Cable(s) to the Coaxial Outlet as shown
in either Figure A or B. Make sure you are using the appropriate
diagram for your home. See the Read First instructions above.
Step
5
Find the Coaxial Outlet near the Wireless Network
Extender. If there is already a coaxial cable plugged into the outlet,
connect the WCB3000N as displayed in Figure C. If there is NOT,
follow the diagram in Figure D.
Step
2
Plug one end of the Yellow Ethernet Cable into an
Ethernet Port on your Router/Gateway. Plug the other end into
the Ethernet Port on the back of the ECB2500C.
Step
3
Plug one end of the Power Adapter into the Power Port
on the back of the ECB2500C and plug the other end into an
Electrical Wall Outlet.
Step
6
Connect the Coaxial Cable to the Coaxial Outlet as shown
in either Figure C or D. Make sure you are using the appropriate
diagram for your home as described in Step 5.
Flip this Quick Start Guide over to continue
NEXT
Installing the Kit
Figure A
Figure B
Figure C
Figure D
Step
7
Plug one end of the Power Adapter into the Power Port
on the back of the WCB3000N and plug the other end into an
Electrical Wall Outlet.
WCB3000N ECB2500C_InstllGd_H_MPAV EA kit QS4.qxd 10/15/13 3:46 PM Page 1