Indesit VRH 600 X EU - Manual (Page 17)

GB
17
Fixing
The appliance must be installed on a perfectly level
supporting surface.
Any deformities caused by improper fixing could
affect the features and operation of the hob.
The thickness of the supporting surface
should be
taken into account when choosing the length of the
screws for the fixing hooks:
• 30 mm thick: 17.5 mm screws
• 40 mm thick: 7.5 mm screws
Fix the hob as follows:
1. Use short flat-bottomed screws to fix the 4
alignment springs in the holes provided at the
central point of each side of the hob.
2. Place the hob in the cavity, make sure it is in a
central position and push down on the whole
perimeter until the hob is stuck to the supporting
surface.
3. For hobs with raised sides: After inserting the hob
into its cavity, insert the 4 fixing hooks (each has its
own pin) into the lower edges of the hob, using the
long pointed screws to fix them in place, until the
glass is stuck to the supporting surface.
 The screws for the alignment springs must remain
accessible.
 In order to adhere to safety standards, the
appliance must not come into contact with electrical
parts once it has been installed.
 All parts which ensure the safe operation of the
appliance must not be removable without the aid of
a tool.
Connecting the hob to the oven
This appliance can only work if it has been connected to
a specific oven, listed on the sheet included in the
documents pouch.
VRH 600 C - VRH 600 X - VRH 640 C - VRH 640 X
- VRH 60 C - VRH 60 X
PIANO INCASSO
CUCINA INCASSO
BIANCO ROSSO GIALLO BLU VERDE
VRH 641 D C - VRH 642 DO X
BUILT-IN CERAMIC HOBS
OVEN
WHITE RED YELLOW BLUE GREEN