Troubleshooting, Respecting and conserving the environment – Indesit BIAxxxx User Manual

Page 19

Advertising
background image

GB

19

Respecting and conserving the

environment

• Install the appliance in a fresh and well-ventilated room. Ensure

that it is protected from direct sunlight and do not place it near
heat sources.

• Try to avoid keeping the door open for long periods or opening

the door too frequently in order to conserve energy.

• Do not fill the appliance with too much food: cold air must

circulate freely for food to be preserved properly. If circulation
is impeded, the compressor will work continuously.

• Do not place hot food directly into the refrigerator. The internal

temperature will increase and force the compressor to work
harder and will consume more energy.

• Defrost the appliance if ice forms (see Maintenance). A thick

layer of ice makes cold transference to food products more
difficult and results in increased energy consumption.

Troubleshooting

If the appliance does not work, before calling for Assistance (see
Assistance), check for a solution from the following list.

The internal light does not illuminate.

• The plug has not been inserted into the electrical socket, or not

far enough to make contact, or there is no power in the house.

• The FREEZRT OPERATION knob is in the position

The motor does not start.

• The appliance comes with a motor protection control (see Start-

up and use).

The refrigerator and the freezer do not cool well.

• The doors do not close properly or the seals are damaged.
• The doors are opened too frequently.
• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

• The refrigerator or the freezer have been over-filled.

The food inside the refrigerator is beginning to freeze.

• The TEMPERATURE ADJUSTMENT knob is not in the correct

position.

The motor runs continuously.

• The door is not closed properly or is continuously opened.
• The outside ambient temperature is very high.

The appliance makes a lot of noise.

• The appliance has not been installed on a level surface (see

Installation).

• The appliance has been installed between cabinets that vibrate

and make noise.

• The internal refrigerant makes a slight noise even when the

compressor is off. This is not a defect, it is normal.

Some of the external parts of the refrigerator become hot.

• These raised temperatures are necessary in order to avoid the

formation of condensation on certain parts of the product.

Advertising
This manual is related to the following products: