C.E. Niehoff & Co. N1224 Alternator Regulator Changeout Instructions - Manual

II0138A
Page 1 of 1
N1224 Alternator
Regulator Changeout Instructions
C. E. Niehoff & Co. • 2021 Lee Street • Evanston, IL 60202 Tech Services Hotline 800-643-4633
Removing regulator from N1224 alternator
1. Remove battery cables from batteries and/or
turn off master switch to disconnect vehicle
batteries from vehicle.
2. Gain access to regulator.
3. Mark cables and harness for ID and reas-
semble reference.
4. Remove cables and harness from regulator.
5. Remove and discard regulator mounting
hardware.
6. Remove regulator.
Re-installing regulator on N1224 alternator
1. Remove battery cables from batteries and/or
turn off master switch to disconnect vehicle
batteries from vehicle.
2. Set new regulator on alternator. Install and
tighten new mounting hardware (in bag sup-
plied with alternator) as shown in Figure 1.
3. Plug harness(es) into alternator as shown in
Figure 1.
4. Attach and tighten cables to terminals as
shown in Figure 1.
5. Reconnect batteries and/or turn on master
switch, start engine, and verify alternator
output/operation.
Figure 1 - Regulator/Harness Attachment
T
Hex Washer Screw M6x1 (2 places) –
Torque to 8.5 Nm/75 lb.in.
Alternator-to-regulator
harness—tighten securely
T
T
AC Terminal:
Torque locknut to
3.4 Nm/30 lb.in.
T
E Terminal:
Torque locknut to
3.4 Nm/30 lb.in.
J1939 harness may or may not be
connected at this location—if so, tighten securely T
This symbol is used to indicate
presence of hazards that can cause
minor property damage.
CAUTION
If vehicle has dual voltage electrical
system, be sure both 14 V and
28 V batteries are disconnected.
CAUTION
I f vehicle has dual voltage electrical
system, be sure both 14 V and 28 V
batteries are disconnected.
CAUTION