Carolina C2616 FOUR-STUDENT WORKSTATION - Manual (Page 4)

Assembly Instructions for
C2616 4-Student Workstation
Items not included but needed for assembly:
1. Phillips head screwdriver
2. ½”Wrench
3. Adjustable pliers 4. Tape measure
5. Utility knife
6. Contact cement
7. Liquid Nail or silicone adhesive (can be found in hardware stores)
Instructions:
1. Place the two base cabinets back to back in the desired location (See Figure 1A). Attach the 13” x 35”
filler panels to the cabinets by drilling pilot holes through the wooden cleats on the back of the
cabinets and attach with #10 x 1 ½ truss head screws (See Figure 1B)
Figure 1A
Figure 1B
2. Level the base cabinets and attach to the floor.
3. Apply the steel rail cleat to the wing assembly with the #8 x ¾” truss head screws.