Ameriphone DIALOGUE XL-25S - Manual (Page 11)

Special Features
Programming the Memory
Buttons
You can automatically dial twelve
programmed telephone numbers
using the memory buttons shown in
Figure 16. Each button can be pro-
grammed (or reprogrammed using
the same procedure) for a phone
number up to 16 digits long.
To program a button, follow these
steps:
Figure 16 - Memory Buttons
Figure 17 - PROG Button
1. Lift the handset and press PROG
as shown in Figure 17.
2. Enter the phone number on the
keypad (Figure 18) just as you
would dial it normally.
3. Press PROG (Figure 17) once
again.
4. Press a memory button (Figure 16)
to store this number on that button.
5. Immediately hang up the handset.
Note:
Any number previously
stored at that button number will
be overwritten.
6. To change a stored number,
repeat the programming process
starting with step 1.
Figure 18 - Telephone Keypad
9