J&M Storm Tracker 2 Track system 3660-36ST-2 - Manual (Page 6)

Pg. 6
SAFETY RULES
ATTENTION! BECOME ALERT! YOUR SAFETY IS INVOLVED!
Safety is a primary concern in the design and manufacture of our products. Unfortunately, our efforts to
provide safe equipment can be erased by an operator’s single careless act. In addition, hazard control
and accident prevention are dependent upon the awareness, concern, judgment, and proper training of
personnel involved in the operation, transport, maintenance and storage of equipment.
Make certain that the operator(s), prior to operating is instructed in safe and proper use and reviews and
understands the manual(s) pertaining to this machine. Also make certain that the operator(s) reviews and
understands the operator’s manual of the grain cart and the tractor.
Read this manual before you operate this machine. If you do not understand any part of this manual, or
need more information, contact the manufacturer or your authorized dealer.
SAFETY
Understand that your safety and the safety of other persons are measured by how you service, and
operate this machine.
The safety information given in this manual does not replace safety codes, federal, state or local laws.
Make certain your machine has the proper equipment as designated by local laws and regulations.
Travel speeds should be such that complete control and machine stability is maintained at all times.
Where possible, avoid operating near ditches, embankments and holes. If a ditch must be crossed, do so
at an angle. Avoid sharp turns to maximize the stability of the road. Reduce speed when turning,
crossing slopes and rough, slick or muddy surfaces. Avoid running over hard objects protruding above
the ground surface, if possible. Damage to the understructure or load may result. If the object is
unavoidable, reduce speed.
Never adjust, service, clean, or lubricate track system until all power is shut off. Keep all safety shields in
place. Support equipment and attachments properly when working beneath them. Do not depend on
hydraulic cylinders to hold them up. An attachment can fail if a control is moved, or if a hydraulic line
breaks. Wear protective glasses when servicing equipment.
SET-UP INSTRUCTIONS
Your Storm Tracker Track System is shipped partially assembled with a Left and Right Side Complete
Track and Belt Unit and a center Cross Beam Axle. IMPORTANT: Be sure the air-bag located on each
Complete Belt Unit is positioned toward the front of the track assembly. To install partially assembled
items, follow the instructions below:
1) Insert the 6” x 27 3/4” Shaft (#50) into each
end of the Cross Beam Axle (#51) and secure
using two 1” x 9” Grade 8 Bolts (#52) and two
1” Grade 8 Lock Nuts (#53).
2) Slide one Rubber O-Ring (#54) across each 6”
diameter shaft into each side track assembly.
Be sure the track assembly is positioned so
the Air Spring (#13) is toward the front of the
unit. Slide another Rubber O-Ring (#54)
across each 6” diameter shaft until it is against
the outside of the track assembly.
3) Secure each track assembly to the cross
beam axle assembly using one 6” collar and
one 1” x 9” Grade 8 Bolt (#52) and one 1”
Grade 8 Lock Nut (#53).