J&M Roll Tarp GRAIN CARTS (May 2011 & Older) - Manual (Page 2)

2
SET-UP INSTRUCTIONS
Roll Tarps for Grain Carts
Place Tightening Lip on top of low side of grain
tank and clamp ends with a vise grips. (NOTE:
Grain Cart models 750-18, 1075-18 and 1075-22
have the Tightening Lips built into the grain cart
extension. For these model carts, this step can
be ignored.)
Position the Front End Panel (with wind lip) over
the front end of the tapered top extensions of the
grain cart. Align and drill 1/4” holes through the
top two pre-drilled holes on each end of the front
panel and attach using 1/4” x 3/4” hex bolts and
1/4” lock nuts. Repeat to mount the Rear End
Panel to the rear rear tapered top extension of the
grain cart.
Place the Bows between the sides of the grain
cart tank. Align the pre-punched holes in the Bows
with the pre-punched holes in the Tightening Lip
and side extension. Attach the Bows using 1/4” x
3/4” hex bolts and 1/4” hex lock nuts.
Position the Bow Supports under the Bows. Attach
the Bow Supports to the steel cross members of
the grain cart by drilling a 3/8” holes in the cross
member and securing with 3/8” x 1” bolt and 3/8”
lock nut. Adjust the height of the Bow Support so
the top of the support cradles the Bow. Secure
the top and bottom of the Bow Supports using a
3/8” x 1” bolt and 3/8” lock nut.
Installing the Tightening Lip, Bows and End Panels
1
2
3
Tightening Lip
Clamp
ends with
Vise Grips
1/4” x 3/4” hex
bolt and lock nut
Front End
Panel with
Wind Lip
Tarp Bow
Tightening
Lip
1/4” x 3/4”
hex bolt and
lock nut
Tarp Bow
3/8” x 1”
Flange
Bolt with
Whiz Nut
Steel
Cross
Member
Adj. Bow
Supports
(Top and
Bottom)