J&M Case IH 66 & 88 series - Manual (Page 2)

Assembly Instructions (Continued)
Step 7:
Push plastic plugs through retainer lanyards and into existing holes from inside extension. Fold end of lanyard around
lynch pin ring and snap into place.
Step 8:
Remove existing sensor from current position. Drill holes and install Sensor Mounting Bracket in center of front panel using
two 5/16” x 5/8” Flange Bolts and two 5/16” Flange Nuts. Bolt sensor to Sensor Mounting Bracket and reconnect.
Folding the Panels
Step One:
Fold the side panels toward the middle of the
combine hopper.
Step Two:
Fold the front and rear panels inward.
Step Three:
Fold the four corner panels.
WARNING:
Use of this product is at the owner’s discretion. Increasing grain capacity may adversely affect center of gravity,
stability, and controllability. Exceeding maximum combine weight loadings can risk structural integrity and drive
line components. J. & M. Mfg. Co., Inc. does not assume any liabilities, or make any warranties regarding the
performance or structure of the combine. See combine owner’s/operator’s manual for specific limitations, operating
recommendations, and safety information.
J. & M. Mfg. Co., Inc.
P.O. Box 547 Ft. Recovery, OH 45846
Ph: (419) 375-2376 Fax: (419) 375-2708
www.jm-inc.com
Step 9:
On the grain tank extension rear panel, position the step
approximately 8” from the lower side of the panel and directly above
the step in the combine tank. Using the step as a template, mark
and drill two 13/32” holes in the rear panel. Attach the step using
(2) 3/8” x 1” Flange Bolts and Flange Nuts. NOTE: Be sure the
step is positioned and mounted as shown.
Combine Grain Tank Set-Up Instructions
for Case IH 1660, 1666, 2166, 2366, 1680, 1688, 2188 & 2388 Series Combines