J&M JD-Walker 2002 and newer - Manual

Combine Grain Tank Set-Up Instructions
for John Deere 9550, 9560, 9660 and 9660 Walker Series Combines Lanyards and
Lynch Pins
shown below
are typical on
Front, Rear
and Side
Panels
Sensor Mounting Bracket,
Hardware and Sensor
Extension Wire
Assembly Instructions
Step 1:
For rear center brace installation, locate flange C on inside rear
wall of grain tank. Position new Rear Center Brace on the side
of the flange nearest the ladder. With the notch on the top of
the new brace under top lip of the grain tank and flush with the
side of the tank flange, mark and drill 5/16” holes. Secure new
brace with 5/16” flange bolts and flange nuts in the top two
holes in the flange and the bottom hole with 5/16” flange bolt
and nut.
# Part # Description Qty
1 JD-CP1 Corner Panel 2
2 JD-CP2 Corner Panel 2
3 JD-FRP-95
JD-FRP-96 Front/Rear Panel (9550, 9560)
Front/Rear Panel (9650, 9660) 2
2
4 JD-LRP Left/Right Panel 2
5 JD-LF-NS Left Frame with cut-out 1
6 JD-RF Right Frame 1
7 JD-AR-95
JD-AR-96 Angle Rail (9550, 9560)
Angle Rail (9650, 9660) 2
2
8 ----- --------------- -------
9 JD-RCB Rear Center Brace 1
10 ----- --------------- -------
11 JD-SMB Sensor Mounting Bracket 1
12 CTE-PP Plastic Plug 8
13 CTE-PL Plastic Lanyard 16
14 CTE-LP Lynch Pin 16
15 JD-EW Extension Wire 1
16 HB-38412 3/8" x 4 1/2" Bolt 8
17 6MM-475 6MM x 4 3/4" Bolt (8.8) 8
18 FB-381 3/8" x 1" Flange Bolt 16
19 FB-51658 5/16" x 5/8" Flange Bolt 5
20 LN-38 3/8" Lock Nut 8
21 6MM-NLN 6MM Nylon Lock Nut 8
22 ----- --------------- -------
23 IW-71212 Inspection Window 4
24 62095-7 Window Molding 4
25 FN-516 5/16" Flange Nut 5
26 FN-38 3/8" Flange Nut 6
27 CTE-SS1 Step 1