Adaptec USB2connect Host Bus Adapter - Manual (Page 10)

5
Installing USB2connect
4 Replace the slot cover screw. When installed properly, the card
should be level with the expansion slot.
5 Close the computer cabinet and reattach the power cord.
The USB2connect AUA-5100 adapter shares one internal and external
connector so that only five can be used at one time. The default setting is
that all external connectors are Enabled, and the internal connector is
Disabled. To switch these settings so that the internal port is enabled, set the
jumpers according to the figure below
.
Changing jumpers on the AUA-5100:
All 5
external
ports
enabled
External Port Enabled (default)
jumpers
disabled
enabled
These 4
ports
enabled
jumpers
Internal Port Enabled
disabled
enabled