Hunter 99179, 99180, 99181 Original Accessory Control and Canopy Kit - Manual (Page 8)

M0093-01 • 02/03/14
1.888.830.1326
8
ON
Turn
Pow
er
Use the pull-chain switch on the
fan to set the fan speed to the HIGH
position before operation.
IMPORTANT
Pairing
Within 3 minutes of restoring power to the
fan, press both the Fan Off button and the High
button for at least 4 seconds. Your fan will turn
on low to indicate successful syncing. If it does
not, turn off power to your fan, wait 1 minute
then try again. If using the transmitter with
multiple fans, repeat this process for each fan.
Note: The remote must be paired before
the fan will operate.
Fan Off
High
To install the transmitter cradle, remove the
two screws holding your switch cover plate.
Do not remove the cover plate. Orient the
cradle by lining up the two mounting holes
with those on the cover plate. Insert and
tighten the screws. Do not over tighten.
Cradle Operation
The Fan Off button only turns the fan
off. To turn the fan on, press one of the
fan speed buttons.
High
Medium
Low
ooo
oo
o
Low
Medium
High
Fan Off