CEMB USA K10_2 (E) - Manual (Page 8)

I 0581 - 8
b b
5 5a
GB
5 - INDICATION AND USE OF THE WHEEL BALANCER
5.1 - Double operator program
This program allows memorizing the dimensions of two types of wheels. Thus two operators can work simultaneou-
sly on two different cars using the same balancing machine. The system memorizes two programs with various
preset dimensions.
1 - Press to select operator (1 or 2). Selection is confi rmed by panel-mounted Led.
2 - Input the dimensions (see
PRESETTING WHEEL DIMENSIONS
)
3 - Press to perform balancing normally
With program 1 or 2 is called for subsequent balancing operations without having to newly enter the dimen-
sions.
5.2 - Setting the wheel dimensions
a)
DYNAMIC balancing of steel or light alloy rims with application of clip-on
weights on the edge of the rim.
From the measurement frame, press
ALU
button to select the desired correction mode.
The illuminated LEDs indicate the position where the weights should be applied. If a spin has already been carried
out, each time the mode is changed, the processor automatically recalculates the unbalance values on the basis of
the new setting.
MEASURING:
SETTING:
- Set the distance “a” between the inside of the wheel
and the machine
- Set the nominal width, normally indicated on the rim, or measure
the width “b” using the caliper gauge supplied.
- Set the nominal diameter “d” indicated on the tyre.
Reading point