CHIEF RPAA1 User Manual
Page 8
RPAA1, B1, C1
Installation Instructions
8
Attaching Projector to Security Mount Drawer
1.
Align projector and security mount drawer so that the
projector is oriented correctly.
2.
Remove the paper backing from the adhesive washers (V)
and attach projector to drawer using adhesive washers (V)
and thumb nuts (P) over the security legs (R). (See Figure 8)
Figure 8
3.
Slide the security mount drawer into the RPAX1 outer
sleeve. (See Figure 9)
Figure 9
WARNING:
Failure to lock RPAX1 can result in serious
personal injury or damage to equipment! Lock RPAX1
BEFORE aligning or adjusting the projector. RPAX1 MUST
be locked when it is loaded.
4.
Lock the RPAX1. (See Figure 10)
Figure 10
Aligning Projector
The RPAX1 may be adjusted for vertical elevation (pitch),
horizontal tilt (roll), and rotation (yaw).
Pitch
Adjust pitch using the adjustment screws on the end of the
adjustment plate. (See Figure 11)
1.
Loosen the pitch adjustment screws.
2.
Adjust projector angle to desired pitch.
3.
Tighten pitch adjustment screws.
Roll
Adjust roll using the two adjustment screws on the back of the
adjustment plate. (See Figure 11)
4.
Loosen the two roll adjustment screws.
5.
Adjust projector to desired roll.
6.
Tighten roll adjustment screws.
Figure 11
(P) x 4
(V) x 4
(R) x 4
Projector
2
Projector
Security
Mount
Drawer
RPAX1
Outer
Sleeve
3
RPAX1
Lock
pitch adjustment screws
roll adjustment screws
4
5
6
1
2
3
5
2