CHIEF RSA Series - Manual (Page 7)

Installation Instructions RSA Projector Mounts
7
1b
Ø 6.3mm
(Ø 1/4”)
64mm
(2-1/2”)
Solid Concrete Installation
1. Determine mounting location.
WARNING: The RSA is designed to be mounted to
a concrete ceiling with a minimum thickness of 8" and
a maximum drywall covering of 5/8".
WARNING: IMPROPER INSTALLATION CAN
RESULT IN SERIOUS PERSONAL INJURY OR
DAMAGE TO EQUIPMENT! Structural members
MUST be capable of supporting five times the
combined weight of all equipment being mounted.
2. Using the RSA as a guide, mark four mounting hole
locations on ceiling using a pencil or similar tool.
3. Drill four 1/4" (6.3mm) diameter pilot holes to a
depth of 2-1/2" (64mm) deep.
4. Align four mounting holes in RSA with four pilot
holes.
IMPORTANT ! : Make sure mount is properly
oriented towards target before securing to
structure.
WARNING: Anchors (not provided) must be
installed into structurally sound solid concrete.
Installation into hollow concrete block, mortar, or
concrete that exhibits cracking, spalling, or other
defects may result in failure of anchor and serious
personal injury or damage to equipment.
5. Install four 3/8" x 2-1/4" Grade 2 concrete anchors
(not included) by inserting into pilot holes and
pounding in until flush with mounting surface.
6. Secure RSA to structure using four #10 flat washers
and four #10 x 3" Phillips head wood screws. (not
included)
3
X4
X4
1
2
(A)
5
X4
6
X (4)