CHIEF RPA Series - Manual (Page 6)

RPA Series Installation Instructions
6
Installing Projector with Interface Bracket
1. Orient projector with interface bracket.
2. Loosen (but do not remove) thumb nuts on the interface
bracket. (See Figure 5)
3. Raise projector with attached interface bracket to RPA
projector mount (A). (See Figure 5)
Figure 5
4. Align the thumb nuts on the interface bracket with the
locating slots on the RPA projector mount. (See Figure 6)
5. Slide the interface bracket with attached projector to the
limit of the locating slots. (See Figure 6)
WARNING: IMPROPER INSTALLATION CAN LEAD TO
PROJECTOR FALLING RESULTING IN SERIOUS
PERSONAL INJURY OR DAMAGE TO EQUIPMENT. Make
certain mounting slots in RPA projector mount base slide
under thumb screws and that screws are seated in the back
of locating slots.
6. Tighten thumb nuts to secure projector in place.
Figure 6
7. Route all cables as required.
2 x 4
3
(Mounting structure not shown for clarity)
(A)
(Mounting structure not shown for clarity)
5
5
x 4 6
Locating slots