CHIEF MTTU - Manual (Page 6)

MTTU Installation Instructions
6
Assembly And Installation
Wall Plate Installation Using Wood Studs
1. Determine location for mount keeping in mind display size
and safety requirements.
2. Use stud finder to locate studs. Wall plate can be mounted
on 2" x 4" wood studs that are 16" apart.
3. Remove and discard two plastic shipping parts from the wall
plate (one from each end). (See Figure 1)
Figure 1
4. Using wall plate as template, mark and then drill four 3/16"
diameter pilot holes through mounting surface making sure
the holes are centered in the middle of each stud. Holes
must be drilled at least 2-1/4" deep. (See Figure 2)
5. Install four connector screws (D) through wall plate and into
pilot holes using M4 Allen Head bit (CC). (See Figure 2)
Figure 2
Wall Plate Installation into Concrete, Concrete
Block or Brick
WARNING: INSTALLING THE MTTU INTO
UNDERRATED OR DAMAGED CONCRETE CAN LEAD TO
SERIOUS INJURY OR DAMAGE TO PRODUCT! When
installing into concrete, only install the MTTU into concrete at
least 8" in depth or into 8"x8"x16" concrete blocks! Never
install the MTTU into cracked, chipped or flaking concrete.
1. Determine location for mount keeping in mind display size
and safety requirements.
2. Using wall plate as a template, mark and then drill four 5/16"
diameter pilot holes through mounting surface. Use level to
make sure wall plate is perfectly horizontal. Holes must be
drilled at least 2-1/4" deep. (See Figure 3)
3. Install four 5/16" anchors (BB) into pilot holes drilled in Step
2. Use a hammer to lightly tap anchors into holes. (See
Figure 3)
4. Install four connector screws (D) through wall plate holes
and into anchors. (See Figure 3)
Figure 3
Front of
wall plate
3
shipping
part
4
X4
X4
5
(D) x 4
4
(D) x 4
3
(BB) x 4
x 4
2
x 4