CHIEF PF2 Series - Manual (Page 6)

MF1, MF2, PF1, PF2 Series Installation Instructions
6
ASSEMBLY
CAUTION: Attachment holes may be damaged if a power
drill is used to insert button head cap screws. Screws should
first be inserted and turned BY HAND with the hex key or with
a handheld screwdriver BEFORE using the hex head drill bit
and power drill to complete the attachment.
Assembling Base for Single Display Stand
CAUTION: INNER COLUMN IS SHIPPED DISENGAGED
and may pinch hands! Hold both inner and outer posts
(columns) while removing from box.
IMPORTANT ! : Press cable tie tab to loosen and
remove cable tie from around knob post. (See Figure 1)
NOTE: Disengage knob on center post BEFORE attaching
base to center post.
1. Lift up slightly on the inner column of center post and hold
firmly toward top of post. (See Figure 1)
2. Pull out knob on the center post and turn 90° in either
direction to disengage the locking mechanism. (See
Figure 1)
3. Raise the inner column and turn the knob 90° in either
direction to engage the knob and lock the column in place.
(See Figure 1)
Figure 1
4. Attach top base section (A) to the center post (F) using four
5/16-18 x 1-1/2" button head cap screws (N) and four 5/16"
flat washers (Q). (See Figure 2)
Figure 2
NOTE: Ensure that post (F) front is placed to the front of base
section (A). Check for "FRONT" on base section (A).
(See Figure 2)
NOTE: Insert and tighten screws in order shown (1, 2, 3, 4) in
Figure 3
.
Figure 3
inner column
Cable
Tie
2
1
NOTE: To help
determine front of
base - distance (1)
is shorter than
distance (2).
(F)
(Front)
(A)
[labeled "FRONT"]
4 (N) x 4
(Q) x 4
1
2
1
2
4
3