CHIEF LFAU Series - Manual (Page 10)

LFAU Installation Instructions
10
Adjustments
Height Adjustment
1. Remove cable cover (G) to expose height adjustment knob.
2. Turn height adjustment knob clockwise to raise display.
(See Figure 13)
3. Turn height adjustment knob counterclockwise to lower
display. (See Figure 13)
WARNING: Do not attempt to raise or lower the adjustment
carriage beyond its upper or lower limit. High and low points
are shown in Figures 13 and 14.
NOTE: A 1/2” socket wrench may also be used to adjust height
by turning bolt just above height adjustment knob.
4. Reinstall cable cover (G) to column assembly.
Figure 13
Figure 14
Pitch Adjustment
5. Turn pitch adjustment knob clockwise to tilt display forward.
(See Figure 15)
6. Turn pitch adjustment knob counterclockwise to tilt display
back. (See Figure 15)
Roll Adjustment
7. Turn roll adjustment knob clockwise to adjust roll to the left.
(See Figure 15)
8. Turn roll adjustment knob counterclockwise to adjust roll to
the right. (See Figure 15)
Figure 15
1
1
2
2
high point
3
3
height adjustment knob
low point
pitch adjustment
knob
roll adjustment
knob
5 6
7 8
7
8
6
5