CHIEF KRA300 - Manual (Page 3)

Installation Instructions KRA300
3
PARTS
ASSEMBLY AND INSTALLATION
1. Remove existing quick release faceplate from monitor arm
by pulling quick release lever and lifting faceplate from arm.
(See Figure 1)
Figure 1
2. Use four M4x12mm Phillips pan machine screws (B) to
attach laptop tray (A) to removed faceplate. (See Figure 2)
Figure 2
3. Slide laptop tray (A) onto mounting head until quick release
tab clicks into place. (See Figure 3)
4. Adjust mounting arm and tray to desired mounting level.
See monitor arm installation instructions for adjustment
details. (See Figure 3)
Figure 3
5. Turn extension rod tension adjustment knob counter-
clockwise to decrease tension. (See Figure 3)
6. Extend laptop extension rod as desired. (See Figure 3)
7. Turn extension rod tension adjustment knob clockwise to
tighten extension rod in place.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components located between the KRA300 up to (and
including) the laptop does not exceed 15 lbs (6.8 kg). Use
with products heavier than the maximum weight indicated
may result in collapse of the mount and its accessories
causing possible injury.
8. Center laptop on tray and adjust pitch tension as needed to
hold tray in desired position. (See Figure 3)
A (1)
[laptop tray]
B (4)
M4x12mm
quick release lever 1
1
(A)
removed faceplate
(B) x 4 2
3
extension rod
7 5
5
(A)
pitch tension
adjustment 8