CHIEF LPAU Series - Manual (Page 9)

Installation Instructions LPAU
9
Cable Management
NOTE: The following cable management options may vary
based on type of display being mounted and user
preference.
1. Use two 1/4-20 x 1/2” Phillips pan machine screws (Q) to
attach two cable hooks (K) to bottom of column assembly
(F). (See Figure 10)
Figure 10
2. Place FCA clip (U) into groove on back of Fusion mount with
clip handle in a vertical position. (See Figure 11)
3. Rotate FCA clip (U) 90° in either direction until clip handle is
in a horizontal position. (See Figure 11)
4. Repeat Steps 1-2 for all clips to be installed.
Figure 11
5. Route cables along FCA clips to be used for cable
management. (See Figure 12)
6. Use cable ties (V) to secure cables to FCA clips. (See
Figure 12)
Figure 12
7. Route cables from display through front channel of column
assembly. (See Figure 13)
Figure 13
(K) x 2 (Q) x 2 1
(F)
2
3
3
clip handle
(U)
5
6 (V)
cable (example)
front channel
7