CHIEF K0 Series - Manual (Page 8)

K0 Series Installation Instructions
8
4. Position display with faceplate attached above mount. (See
Figure 6)
5. Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 6)
Figure 6
Adjustments
Pitch Adjustment
1. Adjust pitch to desired tilt position. (See Figure 8)
2. Adjust pitch tension screw to change the adjustment
tension. (See Figure 8)
Pivot Adjustment
3. Adjust pivot position as desired. (See Figure 8)
4. Use 3/16” hex key (N) to adjust pivot point tension screws
to change pivot adjustment tension. (See Figure 8)
Rotational Adjustment
NOTE: (Optional) Rotational adjustment may be locked by
installing rotational locking screw (M) into back of
faceplate. (See Figure 7)
Figure 7
5. The monitor may be adjusted 90 degrees in either direction
in order to provide a portrait view of the monitor. (See Figure
8)
6. Use 3/16” hex key (N) to adjust rotational adjustment screw
to adjust rotational tension. (See Figure 8)
Figure 8
Display Removal
WARNING: Only remove display from mount when the
display can be lifted up from the mount! DO NOT remove
display unless the display is in the upright position! (See
Figure 9)
1. Make sure display is in the upright position.
2. Remove quick release faceplate from mount by pulling
quick release lever and sliding faceplate off mount. (See
Figure 9)
Figure 9
5
(M)
pitch
pivot point
tension
tension
5
1
3
rotational tension
quick release tab
2