CHIEF K1P Series - Manual (Page 12)

K1P Series Installation Instructions
12
Cable Management
1. Press insides of cable management covers at both ends to
unhinge tabs on either end of cable management cover on
upper arm. (See Figure 18)
2. Lift cable management cover up until tabs are unhinged and
cover is in the “open” position. (See Figure 18)
Figure 18
Figure 19
3. Route cables through cable management channels. (See
Figure 19)
IMPORTANT ! : Be sure to leave enough slack in the
cables near display and arm joint to allow for full arm
articulation!
4. Close cable management covers on monitor arm. (See
Figure 19)
5. Repeat Steps 1-4 for lower arm.
Array Models
1. Install array cable clips (J7) to back of array. (See Figure 20)
2. Route cables through array cable clips (J7) as desired. (See
Figure 20)
3. Route cables through arm cable clips as desired. (See
Figure 20)
Figure 20
cable management cover tabs
1
2
2
2
4
4
3
3
cable (typical)
(J7)
2
1
3