CHIEF K1D Series - Manual (Page 11)

Installation Instructions K1D Series
11
4. Position display with faceplate attached above mount. (See
Figure 11)
5. Slide faceplate onto mounting head until quick release tab
clicks into place. (See Figure 11)
Figure 11
Display Installation - Custom Faceplate
IMPORTANT ! : Custom interface brackets are designed
specifically for Dell’s quick-connect style monitors. Do not
attempt to install any other type of monitors to these
mounts!
1. Position monitor over mounting tabs on quick-connect
bracket (A). (See Figure 12)
2. Lower monitor onto quick-connect bracket, inserting
mounting tabs into top two top mounting holes on back of
monitor. (See Figure 12)
Figure 12
3. Slide base of monitor towards mount until lower tabs secure
display to mount. An audible “click” should be heard. (See
Figure 13)
Figure 13
Handle Installation (K1D22H models only)
1. Loosen four screws securing handle brackets to K1D22H
array. (See Figure 14)
2. Install uprights of handle (J2) into handle brackets located
on the back of K1D22H array. (See Figure 14)
Figure 14
5
2
mounting
tabs
3
(side view)
2
2
(J2)
1 x 4