CHIEF KWK-110 - Manual (Page 5)

Installation Instructions KWK-110
5
INSTALLATION
WARNING: FAILURE TO PROVIDE ADEQUATE
STRUCTURAL STRENGTH FOR THIS MOUNT CAN
RESULT IN SERIOUS PERSONAL INJURY OR DAMAGE
TO EQUIPMENT! It is the installer’s responsibility to make
sure the structure to which this mount is attached can support
five times the combined weight of the mount and all
equipment attached to it. Reinforce the structure as required
before installing the mount.
Installation to Wood Studs
1. Determine location for mount keeping in mind extension
and height adjustment requirements.
2. Using wall plate (C) as a template, mark location for two
pilot holes through top and bottom holes of wall plate. (See
Figure 1)
Figure 1
3. Drill two 1/8" diameter pilot holes through marked locations
into wall structure. (See Figure 1)
4. Using 7/16" wrench, loosely install two 1/4" x 2 1/2" hex
head lag screws (D) through two 1/4" washers (E), wall
plate (C), and drywall into wood stud. (See Figure 1)
5. Ensure wall plate (C) is vertical, then tighten screws (D).
CAUTION: DO NOT OVERTIGHTEN FASTENERS!
Overtightening screws may cause wall bracket to compress
into soft wall surface, resulting in difficult mount installation or
improper engaging of set screw in later step.
6. Insert top of KWK-110 (A) over lip at top of wall plate (C).
(See Figure 2)
7. Swing KWK-110 down flush against wall. (See Figure 2)
Figure 2
8. Use 5/32" hex wrench (L) to tighten set screw in bottom of
KWK-110. (See Figure 3)
NOTE: Ensure set screw engages on back side of wall plate
(C) to properly secure KWK-110. (See Figure 3)
Figure 3
2
4
3
(D) x 2
(C)
(E) x 2
(C)
(A)
6
7
Set
Screw
8
(C)
(A)