CHIEF NE1F20-28-36-44 - Manual (Page 5)

Installation Instructions NE1F20-28-36-44
5
INTRODUCTION
The E1 Series racks may be configured with optional
accessories (not included) such as doors, levelers, casters, fan
panels, etc. All accessory installation instructions accompany
the accessories.
NOTE: The top cover panels may be removed and replaced
with fan panels (follow instructions included with the fan
panels), or other 3U panels (remove four nuts, replace
existing panel, and replace and tighten nuts.) (See
Figure 1)
NOTE: The bottom cover panel may be removed for wire entry
or may be replaced with a filtered fan panel. Follow
instructions included with the fan panel. (See Figure 1)
Figure 1
ASSEMBLY
1. Add optional levelers (not included) or casters (not
included) to the rack following instructions included with the
levelers or casters.
2. Add optional door(s) (not included) to the rack following
instructions included with the door(s).
IMPORTANT ! : If the door(s) are to be attached with the
pull-ring handle on the right side, the grounding screw,
washer and wire already installed on the door must be
removed and reinstalled on the opposite end of the door.
See instructions included with the door(s).
NOTE: If NOT adding door(s), proceed to Step 6.
Figure 2
Figure 3
May be replaced
May be removed
for wire access or
replaced with a fan panel
with fan panels or
other 3U
panels
(front view of rack)
Grounding screw and nut
installed at factory
affixed adjacent to grounding terminal.
Earthing symbol IEC 60417 No. 5019
Locations of
grounding lugs