CHIEF KTA1007 Series - Manual (Page 3)

Installation Instructions KTA-1007
3
TOOLS / PARTS FOR INSTALLATION
1/2"
9/16"
A (1)
3/8-16 x 6"
B (2)
[grommet plate]
ASSEMBLY AND INSTALLATION
1. Locate desired point on surface where mount is to be
installed.
1. Drill a 1/2" diameter hole through surface.
1. Align grommet mount base plates (B) with hole in surface.
(See Figure 1)
1. Slide one 3/8-16 x 6" hex head cap screw (A) upward
through lower grommet plate (B), through hole in surface
and through upper grommet plate (B). (See Figure 1)
Figure 1
2. Place pole, provided with array accessory, onto upper
grommet plate (B) aligning threaded hole in pole bottom with
threaded end of 3/8-16 x 6" hex head cap screw (A). (See
Figure 1)
3. Thread 3/8-16 x 6" hex head cap screw (A) into pole bottom
and tighten with 9/16" wrench to secure pole and grommet
plates (B) to surface. (See Figure 1)
4. Mount Centris head assembly or array assembly to pole
following the instructions outlined in the instructions
provided with the mount.
Cable Management (optional)
1. Connect cables to display(s).
2. Route cables through holes on grommet plates (B) and hole
in desk. (See Figure 2)
Figure 2
(B) x 2
(A) 6
cable (typical)
(B) x 2