CHIEF KFA320 Series - Manual (Page 2)

KFA SERIES Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® and Centris™ a registered trademarks of Milestone AV
Technologies. All rights reserved.
IMPORTANT WARNINGS AND
CAUTIONS!
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING: Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
the displays installed does not exceed 70 lbs (31.8 kg) for the
KFA-220 and KFA-225 and 90 lbs (40.8 kg) for the KFA-320
and KFA-325. The weight of each individual display must not
exceed 35 lbs (15.9 kg) for the KFA-220 and KFA-225 or 30
lbs for the KFA-320 and KFA-325.
WARNING: RISK OF ELECTRIC SHOCK ! Using the
wrong screws could result in severe personal injury or
damage to your display. If your display uses a longer screw
size than those included in the kit, DO NOT use the screws
provided with the kit. Use the screws provided with your
display or contact the manufacturer.
WARNING: Improper installation can result in serious
personal injury! Make sure that the mounting surface can
support a redundant weight factor five times the total weight
of the equipment. If not, reinforce the mounting surface
structural members before installing the mount.
WARNING: Be aware of the potential for personal injury or
damage to the unit if it is not adequately mounted.
WARNING: The installer is responsible for verifying that
the mounting surface to which the KFA is anchored will safely
support the combined load of all attached components or
other equipment.
WARNING: Watch for pinch points. Do not put your fingers
between movable parts.
WARNING: Make sure the mount is correctly oriented.