CHIEF FSA1013 - Manual (Page 4)

FSA1013 Installation Instructions
4
INSTALLATION
Existing Mount Preparation
If the FSA-1013 is being installed on an existing Chief swingarm
style mount the existing mount needs to be modified before
installation of the FSA-1013. If there is no existing mount
proceed to "Tray Installation" section below
To prepare the existing mount:
1. Disconnect all cables and wiring from display.
1. Remove display, if present, from existing mount following
the instructions supplied with mount.
2. Loosen button head cap screw securing display end of
mount to mount arm using a 5/32" hex key.
3. Uninstall button head cap screw, one nylon washer, and two
flat washers from swing arm and set aside for reuse.
(See Figure 2)
4. Remove large nylon washer, pivot pin, and Nylock nut from
existing mount base and set aside for reuse.
(See Figure 2)
Figure 1
Tray Installation
To install the KSA-1013:
1. Place pivot pin (D) into mount end. (See Figure 2)
2. Place nylon spacer (E) on top of mount end.
3. Assemble UHMW washer (F) to BHCS (H or J).
4. Install threaded end of BHCS (H or J) through access hole
in tray top and down through mounting tab of tray assembly
(A), down through spacer (E), pivot pin (D) and through
mount end.
5. Slide Nylock nut (G) up into bottom of mount end.
6. Hold Nylock nut (G) in bottom of mount and tighten BHCS
(H or J) to desired tension. (See Figure 2)
Figure 2
Laptop Installation
To install a laptop computer onto the KSA-1013:
1. Loosen the two locking thumbscrews on tray bottom.
2. Pull Slide trays outward to fully open position.
(See Figure 3)
Figure 3
Nylock Nut
Flat Washer
Swing Arm or other
Large Nylon Washer
Existing Mount Base
Flat Washer
BHCS
Nylon Washer
Pivot Pin
mount end.
A (1)
D (1)
H or J (1)
F (1)
G (1)
E (1)
Mount Arm
Locking Thumbscrews
Slide Tray
View from tray bottom