CHIEF TA300 - Manual (Page 6)

TA300 Installation Instructions
6
Speaker Bracket Installation
1. Use four #10-24 x 3/8" Phillips machine screws (D) to
connect one speaker bracket (C) to upper and lower
horizontal brackets (A). (See Figure 5)
Figure 5
2. Slide connected horizontal brackets (A) and speaker
bracket (C) onto back of display until center two holes on top
horizontal bracket are aligned with two slots on top of
attachment bracket (B). (See Figure 6)
Figure 6
3. Use two #10-24 x 1/2" button head cap screws (F) and two
#10 washers (G) to connect top horizontal bracket (A) to
attachment bracket (B). (See Figure 7)
Figure 7
4. If necessary, extend arms beyond edge of display by
loosening (not removing) extension adjustment screws on
horizontal brackets and extending arms. Tighten
adjustment screws when desired position is reached. (See
Figure 8)
5. Use four #10-24 x 3/8" Phillips machine screws (D) to
connect second speaker bracket (C) to upper and lower
horizontal brackets (A). (See Figure 8)
Figure 8
(A) x 2
(D) x 4 1
(C)
2
2
2
(F) x 2
(G) x 2
(B)
3
4
extension adjustment
screw
5 (D) x 4
4
4