CHIEF PACLR1 - Manual (Page 7)

Installation Instructions PACLR1
7
Install Accessory to Mount and Display to
Accessory
1. Install accessory to mount following the installation
instructions provided with the mount. (See Figure 9)
Figure 9
2. Verify latching flag is in the OPEN position. (See Figure 10)
3. Align four mounting buttons on display with four teardrop
mounting holes in accessory.
4. Slide mounting buttons into teardrop mounting holes and
lower display until recessed area of mounting buttons is
seated in lower area of teardrop mounting holes.
WARNING: IMPROPER INSTALLATION CAN LEAD TO
DISPLAY FALLING CAUSING SEVERE PERSONAL
INJURY OR DAMAGE TO EQUIPMENT. Make sure ALL
mounting buttons are properly seated in lower area of four
teardrop mounting holes.
5. Move latching flag to CLOSED position to secure display on
accessory. (See Figure 10)
NOTE: A padlock or similar device can be used to provide
additional security.
6. Install speaker mounting brackets with speakers to speaker
mounting rails by using four button head cap screws and
four washers set aside earlier. (See Figure 11)
Figure 10
Figure 11
1
2
3
4
5
Display
CLOSE
Latching Flag
OPEN
X4
Speaker Mounting
Bracket
(1each end)
Speaker not shown for clarity