CHIEF PACGB1 User Manual
Pac-gb1, Metal single gang box), Parts
I N S T A L L A T I O N I N S T R U C T I O N S
PAC-GB1
(Metal Single Gang Box)
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of
Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8807-002007 Rev00
©2009 Milestone AV Technologies,
a Duchossois Group Company
06/09
The PAC-GB1 kit is designed for use with Chief® Series Mounts.
See the specific installation instructions provided with the mount for
additional installation information.
Unpack and verify kit contents. If any listed parts are missing,
immediately contact a Chief Customer Service representative.
WARNING:
IMPROPER INSTALLATION CAN RESULT
DEATH OR SERIOUS PERSONAL INJURY! This accessory
should be installed by qualified personnel.
PARTS
WARNING:
ELECTRICAL SHOCK HAZARD!
CUTTING OR
DRILLING INTO ELECTRICAL WIRES OR CABLES CAN
CAUSE DEATH OR SERIOUS PERSONAL INJURY!
ALWAYS make certain area behind mounting surfaces is free of
electrical wires and cables before cutting, drilling, or installing
fasteners.
®Chief is a registered trademark of Milestone AV Technologies. All rights reserved.
WARNING:
EXPLOSION AND FIRE HAZARD! CUTTING OR
DRILLING INTO GAS PLUMBING CAN CAUSE DEATH OR
SERIOUS PERSONAL INJURY! ALWAYS make certain area
behind mounting surfaces is free of gas, water, waste, or any
other plumbing before cutting, drilling, or installing fasteners.
1.
Install metal single gang box (A) into the in-wall enclosure using
four 08 x 1/2" Phillips pan head tap screws (B). (See Figure 1)
Figure 1
2.
Continue installation following the instructions included with the
in-wall enclosure.
(Qty) Description
A
(1) Metal Single Gang Box
B
(4) Screw, Phillips Pan Head, 08 x 1/2"
A (1)
[Metal Single
B (4)
08 x 1/2"
Gang Box]
(B) x 4
(A)
(FAC501 shown)