CHIEF NAGS1 User Manual
Nags1
I N S T A L L A T I O N I N S T R U C T I O N S
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
8401 Eagle Creek Parkway, Savage, MN 55378
• P: 800.582.6480 / 952.894.6280 • F:877.894.6918 / 952.894.6918
8821-002019 Rev00
©2010 Milestone AV Technologies,
a Duchossois Group Company
09/10
NAGS1
S1 Ganging Hardware
The NAGS1 ganging hardware is designed for use with Chief® S1 Raxxess racks. See the specific installation instructions provided with the
rack for additional installation information.
TOOLS REQUIRED / PARTS INCLUDED
WARNING:
FAILURE TO READ, THOROUGHLY UNDERSTAND, AND FOLLOW ALL INSTRUCTIONS CAN RESULT IN SERIOUS
PERSONAL INJURY, DAMAGE TO EQUIPMENT, OR VOIDING OF FACTORY WARRANTY! It is the installer’s responsibility to make
sure all components are properly assembled and installed using the instructions provided.
A (4)
[Ganging hardware]
INSTALLATION INSTRUCTIONS
1.
Remove eight Phillips head screws from top and bottom front of
rack. (See Figure 1)
Figure 1
2.
Connect the racks by attaching the ganging hardware (A) at the
top and bottom of the rack using the eight Phillips head screws
removed in Step 1. (See Figure 2)
Figure 2
3.
Repeat Steps 1 and 2 for the back of the racks.
1
x 8
2
x 8
(A)
(A)