CHIEF LCSW1 User Manual
Important safety instructions
Milestone AV Technologies, and its affiliated corporations and subsidiaries (collectively, "Milestone"), intend to make this manual accurate and complete. However, Milestone makes
no claim that the information contained herein covers all details, conditions or variations, nor does it provide for every possible contingency in connection with the installation or use
of this product. The information contained in this document is subject to change without notice or obligation of any kind. Milestone makes no representation of warranty, expressed or
implied, regarding the information contained herein. Milestone assumes no responsibility for accuracy, completeness or sufficiency of the information contained in this document.
Chief Manufacturing, a products division of Milestone AV Technologies
6436 City West Parkway, Eden Prairie, MN 55344
• P: 800.582.6480 / 952.225.6000 • F:877.894.6918 / 952.894.6918
8800-002203 Rev00
©2012 Milestone AV Technologies,
a Duchossois Group Company
07/12
I N S T A L L A T I O N I N S T R U C T I O N S
The LCS-W1-12/-20/-28/-36 Lacer Strips Kits are designed for use
as cable management in Chief® Series NW1 racks.
IMPORTANT SAFETY INSTRUCTIONS
WARNING:
Failure to read, thoroughly understand, and follow
all instructions can result in serious personal injury, damage to
equipment, or voiding of factory warranty! It is the installer’s
responsibility to make sure all components are properly
assembled and installed using the instructions provided.
TOOLS FOR INSTALLATION / PARTS
INCLUDED
INSTALLATION
NOTE:
The lacer strip (A) may be placed on the studs on either the
left or right side of back inside wall.
1.
Place nylon spacers (B) over studs on back inside wall of NW1
rack. (See Figure 1)
2.
Place lacer strip (A) over nylon spacers (B).
3.
Fasten lacer strip in place using 1/4-20 nuts (C) over studs on
back inside wall of NW1 rack.
Figure 1
Chief® is a registered trademark of Milestone AV
Technologies. All rights reserved.
QUANTITIES
LCS-W1-12 LCS-W1-20 LCS-W1-28 LCS-W1-36
A
[Lacer strip]
B
[.61x.28x.50]
C
1/4-20
1
3
3
1
(Appearance
varies
per model)
3
3
1
4
4
4
4
1
7/16"
(B)
(A)
1
(C)
Stud
(Some parts removed to show back wall of NW1 rack clearly.)
LCS-W1-12 / LCS-W1-20 / LCS-W1-28 / LCS-W1-36 Lacer Strips Kits