CHIEF YAMF1 - Manual (Page 7)

Installation Instructions YAMF1
7
Height Adjustable Arm
IMPORTANT ! : It is important that the mount be
attached to the mounting surface AND display be
attached to the mount BEFORE attempting to adjust the
height adjustable arm.
1. Using 3/32" hex key (T), slightly loosen or tighten the
adjustment screw as necessary (See Figure 9).
• If display settles on its own, then rotate
adjustment screw counterclockwise (towards the
"+" symbol).
• If display rises on its own, then rotate adjustment
screw clockwise (towards the "-" symbol).
NOTE: It may be necessary to raise or lower the height
adjustable arm to expose the adjustment screw.
Figure 9
Centris Head
1. If previously attached, disconnect cables from display, then
remove display.
2. Using Phillips screwdriver, slightly loosen or tighten the
adjustment screw as necessary (See Figure 10).
Figure 10
3. Install mount and then display cables. See Installing
Display section.
Adjustment Screw 1
(Display not shown)
2 Adjustment Screw