C-Squared Hydrogen Analyzer Manual User Manual
Page 2
Hydrogen Discrete Analyzer Instruction Manual
Page 2
C-Squared Inc. 1440 S State College Blvd, Unit 4L, Anaheim, CA 92806
Tel: (714) 999-2791, Fax: (714) 999-2928,
Operation
The operation of the unit is very simple and does not require a flow control regulator. The
operation is as simple as 1, 2, 3.
Step 1. Pull up the sensor cap and flow gas mixture
through the gas inlet with a steady flow for about 10
seconds. (Enough time to clear the line of any existing
gas).
Step 2. Push the sensor cap down firmly to stop the gas
flow and seal the gas mixture inside the device.
Step 3. Turn on the power switch and wait for the display to give a stable reading (less than
one minute), which is the percentage content of helium in the gas mixture tested.
Note: Always turn off the power after you take the reading to extend the battery life
between charging.
Gas
mixture
Pull
Pus
h