ALLIED Vision Technologies Manta G-917 - Manual (Page 18)

Manta Technical Manual V7.0.1
18
Camera cleaning instructions
Camera cleaning instructions
This chapter describes safety instructions/cautions valid for Manta cameras in
case of cleaning lenses, optical filters/protection glass or sensors.
Warranty
Avoiding the necessity of camera cleaning
When screwing/unscrewing the camera lens or dust cap, hold the camera with
the C-Mount / CS-Mount opening towards the floor as shown in figure 1. This
minimizes the possibility of any contaminants falling on the glass surface.
Always store cameras and lenses with dust-caps installed.
Note

• Please read these instructions before you contact your
AVT camera dealer for assistance.
• Ask your AVT camera dealer if you are not familiar with
the procedures described below.
Caution

Warranty precautions
• To ensure your warranty remains in effect:
– Do not open the camera housing.
– Follow instructions described below.
– Use only optical quality tissue/cloth if you must clean
a lens or filter.
– Use only optics cleaner (60% ethyl alcohol, 40%
ether). Never use aggressive cleaners like benzine or
spirit. Such cleaners may destroy the surface.
– Do not use compressed air which can push dust
into camera and lens.
• AVT does not warranty against any physical damage to
the sensor/filter/protection glass or lenses. Use utmost
care when cleaning optical components.
Figure 1: Illustration of camera orientation when removing lens or dust cap