Controls and indicators – Advent TOCMR-OE100 User Manual
Page 7
7
Turning the Unit ON or OFF:
Press the front panel PWR button to turn the unit on. The unit can also be turned
on buy pressing the front remote control power button. To turn the unit off, press
and hold the front panel PWR button for 2 seconds or press the front remote con-
trol power button.
Volume Adjustment:
To increase or decrease the volume level, turn the front panel PWR button or press
the VOL+/ VOL- buttons on the front remote control. The unit’s front panel screen
will display the volume level for 3 seconds. The volume ranges from “0” to “40”.
Mute:
Pressing the PWR VOL button on the front panel or either the front or the rear
remote control will mute the audio from the unit. Press the MUTE button again to
restore the audio volume. “MUTE” ( or ) is displayed on the monitor. Adjust-
ing the volume or using any of the audio setup features cancels the mute function.
Also pressing the front panel PWR button will mute or unmute the audio from the
unit
Equalizer Control Menu :
The Equalizer Control menu can be accessed by pressing the front panel SEL TUNE
knob or by pressing SEL on either the front or rear remote control. The Equalizer
Menu features a 6-band graphic equalizer, which allows you to easily adjust your
audio system to meet the acoustical characteristics of your vehicle, which vary de-
pending on the type of vehicle and its measurements. Proper setting of the Fader
and Balance boosts the effects of the cabin equalizer. The Equalizer Control menu
applies preset sound effects to the unit’s audio output signal. The “EQ SETTING”
right or left cursor buttons when pressed, will activate one of eleven operating
modes: User, Flat, Jazz, Pop, Classical, Rock, News, Urban, Rave, Movie, Techno.
When the “EQ SETTING” is set to a preset sound, such as Flat, Jazz, Pop etc.,the bass
and treble levels cannot be changed. Press the SEL Tune Knob to exit the equalizer
menu screen.
NOTE: All the various audio settings can only be adjusted when the “EQ SETTING”
is set to USER.
Controls and Indicators