AmpliVox SW223 - Manual (Page 4)

4
Battery Power
1. The amp uses 10 " D " size Alkaline batteries (not
included); or the optional rechargeable AmpliVox NiCad
Battery Pack (S-1465) and (S1460) AC adapter -
purchase separately (Fig 3).
2. Open case and locate battery holder (Fig 1).
3. Lift the battery holder out (Fig 2).
4. Install 10 fresh Alkaline " D" size batteries. Be sure to
observe the polarity when putting batteries in the battery
compartment. The negative (flat) ends go against the
springs. Carefully replace battery holder.
DO NOT MIX BATTERY TYPES OR ATTEMPT TO
RECHARGE ALKALINE BATTERIES. EQUIPMENT
DAMAGE, SAFETY HAZARD OR FIRE COULD RE-
SULT.
Note: The battery holder cable comes from the factory
already plugged into the connector. If it comes loose,
push it in securely. (Turn the plug over if it doesn’t fit; it
only fits one way.)
5. Close case.
6. If using the S-1465 NiCad Battery pack
(Fig 3), Plug AC Adapter/ Recharger power
supply (S1460) into the “DC IN” jack on
front panel of the amp. Plug into a working
electrical outlet. Charge 24 hours for full
charge before using.
Wireless Headphone/Lapel Bodypack
Transmitter for Model SW222
 Battery: The wireless headphone transmitter bodypack
(S1690T) is operated by 1 - "AA" alkaline battery. Before
use, install battery as shown (Fig. 4). Make certain the
battery is fully seated in its compartment so the cover
slides in place easily. Battery life with alkaline batteries is
approximately 8 hours of operating time. When LED on
top panel turns to RED the battery should be replaced
immediately.
Fig 4
Fig 3
Fig 2
Fig 1
INSTALL BATTERIES
 Plug the Lapel / Headset microphone into the Mic Input
Jack (B). The Lapel microphone can be clipped to a
necktie or other clothing, using the supplied clip. The
lapel mic should be placed under the chin, as close to
the center of the body as possible
 Select Channel Number (see next page item 15 & 16)
 To turn on transmitter, slide the 3 position switch (ON /
MUTE / OFF) (A) to the ON position (the LED indicator
light will illuminate green). Replace batteries when this
LED turns red.
 When wireless power switch (14) on control panel is
turned on, the RF LED located above the channel selec-
tor (15) will light, meaning that it is receiving signal. If RF
LED does not light, check channel numbers. When both
RF LED’s are on, speak into microphone and rotate
“VOLUME” control knob to obtain desired loudness lev-
el.
A B
S-1460
S-1465