Receiver controls and functions, Transmitter setup, controls and functions – AmpliVox S1660 User Manual

Page 4

Advertising
background image

4

Receiver Controls and Functions

(Continued)

8.

UNBALANCED AUDIO OUTPUT JACK:

1

/

4

" phone jack. Can

be connected to an unbalanced aux-level input of a mixer,
guitar amp or tape recorder.

9.

AF LEVEL (VOLUME) CONTROL: Adjusts audio output level
of both AF Output jacks; maximum output is fully clockwise.

12

11

Figure C-Rear Panel Controls and Functions

10

9

8

10. BALANCED AUDIO OUTPUT JACK: XLRM-type connector.

A standard 2-conductor shielded cable can be used to
connect the receiver output to a balanced microphone-level
input on a mixer or integrated amplifier.

11. CORD HOOK: Loop the cord around the cord hook to keep

the DC plug from pulling out accidentally.

12. POWER INPUT JACK: Connect the DC plug from the included

in-line AC adapter.

Transmitter Setup, Controls and Functions

Battery Selection
Two 1.5V AA alkaline batteries are recommended.

UniPak™ Transmitter Battery Installation
1.

Open the transmitter door by first pulling the catch down
and then sliding the door upward (Fig. D).

2.

Observe correct polarity as marked and carefully insert two
fresh 1.5V AA alkaline batteries (Fig. D).

3.

Slide the door closed, making certain it clicks securely in
place.

Figure D-UniPak Transmitter

Handheld Transmitter Battery Installation
4.

Unscrew the lower body cover, slide it downward, and
remove it to expose the battery compartment.

5.

Observe correct polarity as marked inside the battery
compartment and carefully insert two fresh 1.5V AA alkaline
batteries. Insert the first battery and slide it toward the
spring contact. Then insert the second battery into the
space remaining. Make certain the batteries are fully seated
in the battery compartment. (Fig. E)

6.

Slide the lower body cover back on and screw the housing
together. Do not overtighten.

Note: Remove batteries from the handheld transmitter starting
at the bottom end, where finger indents in the battery housing
are provided for easy grip.

Figure E-Handheld Transmitter Battery Compartment

Screwdriver

Transmitter
Door Catch

Battery
Compartment

Transmitter
Door

Battery

Compartment

RF Power
Select
Switch

Screwdriver

Transmitter
Door
(Open
Positon)

Channel
Selector

Switch

Advertising
This manual is related to the following products: