Analog Way Secure Power Unit - Manual (Page 4)

05/16/2014 - SPU001-QSG
Code: 140156
This Analog Way product has a 1 year warranty on parts and labor (except for the power supply, the frame
head and the battery that are under warranty only in case of “Dead On Arrival”). This warranty does not
include faults resulting from user negligence, special modifications, electrical surges, abuse (drop/crush),
and/or other unusual damage. In the unlikely event of a malfunction, please contact your local Analog Way
office for service.
Hot swap:
You may wish to replace defective elements while the installation is running.
To replace a defective power supply unit while the LiveCore™ device is running, follow these steps (taking the
usual safety measures against ESD):
• Unplug the power cable from the mains,
• Unplug the power cable from the defective Power Supply Unit and take it off,
• Fit the new Power Supply Unit,
• Plug the IEC power cable to the Power Supply Unit,
• Connect the power cable to the mains.
To replace the battery, put the LiveCore™ device in stand-by, replace the battery then turn on the LiveCore™
device.
WARRANTY AND SERVICE
The third step is to connect the Secure Power Unit to the
LiveCore™ through an RS232 cable. It will provide information
about the Secure Power Unit directly on the Web RCS
interface. Connect the ground between the Secure Power
Unit and the LiveCore™ device.
The last step is to power the Secure Power Unit. The LiveCore™
device is ready to run safely.
WARNING: In order to power the Secure Power Unit, plug IEC
cables first in the Secure Power Unit then plug into the mains
power.
STEP #3 STEP #4
1
2
1
1
2