Auto Page RS-860 lcd - Manual (Page 7)

7
C: PROGRAMMING OF THE LCD REMOTE TRANSMITTER:
Transmitter Button Description Operation
(1 second)
LCD screen lamp turns on
for
5 seconds. Press and hold for 1 second
1 melody sound to confirm
enters.
(3 seconds)
Timer Programming Mode. Press and hold for 3
seconds
2-melody sounds to confirm
enter.
(5 seconds)
Power Save Mode Press and hold for 5
seconds
1 melody sound to confirm
enters.
- -
Clear the Flash Icon and
Melody Sound on the LCD
Screen Transmitter Press within 3 seconds
-
(2-second)
Button Lock ( ) enable /
disable
Press within 3 seconds
-
(2-second)
Melody / Vibration ( )
Mode
Press within 3 seconds
-
(2-second)
Program Count Down Timer
( ) (10-Minute / 20M / 30
M /1Hour /1.5H / 2.0H)
Within 3 seconds press the
button until desired
time is set, then flashes
-
(2-second)
Enable / Disable Bi Sound
(Bi) While Pressing Button
1. Screen Lamp ON: Press and hold the button one second, with one
melody sound and the LCD
screen lamp will turns on for 5 seconds
2. Power Save Mode:
While the power save mode, the LCD remote
transmitter uses “0” current to save the battery power.
Entry: 1. Press & hold the button for 5 seconds, with one
melody sound and icon on the LCD screen to indicate
entry the “power save mode”.
2. Under the “Active Arming Mode” and Disarm mode. Turn the
ignition switch to on, the LCD remote transmitter will automatically
entry the “Power Save Mode”
Exit: Press any button of the LCD remote transmitter to exit the
“Power Save Mode”.
3. Clear the Flash Icon and Melody Sound: Press the button 3 times
within 3 seconds will clear the
flash icon and melody sound on the LCD screen transmitter
4. Stop The Trigger Melody Sound:
While triggering the alarm the LCD
screen will alert user through melody sound and flashing trigger icon, press
any button on the LCD remote transmitter to stop melody sound only.