BEI Sensors MHK5 Absolute Hollow Shaft Encoder User Manual
BEI Sensors Sensors
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- 1 General
- 2 Installation
- 2.1 Settings in the connection cap
- 2.2 Connecting bus lines and power supply
- 2.3 Connecting-up the connection capwith cable glands
- 2.4 Assignment for M12 connectors (AH58-B1DP-072)
- 2.5 Connecting the screen
- 2.6 Instructions for mechanical installation and electrical connection of the angular encoder
- 3 Device Configuration
- 4 Class 1 and Class 2 profile
- 5 Special versions 2.1 and 2.2
- 6 Diagnostic messages
- 6.1 Overview
- 6.2 Supported diagnostic messages
- 6.2.1 Extended diagnostics header
- 6.2.2 Memory error
- 6.2.3 Operating status
- 6.2.4 Encoder type
- 6.2.5 Singleturn resolution
- 6.2.6 Number of revolutions
- 6.2.7 Operating time warning
- 6.2.8 Profile version
- 6.2.9 Software version
- 6.2.10 Operating time
- 6.2.11 Zero offset
- 6.2.12 Programmed resolution
- 6.2.13 Programmed total resolution
- 6.2.14 Serial number
- 6.3 Status indication by the LEDs in the connection cap
- 7 Configuring with STEP 7
- 8 Technical Data
- 9 Dimensioned Drawings
- 10 Appendix
- 11 Index
- Revision index