BEI Sensors Programmable Hall Device - Manual

Tel: 805-968-0782 /800-350-2727 | Fax: 805-968-3154 /800-960-2726 | 7230 Hollister Ave., Goleta, CA 93117-2807 | www.beisensors.com
Specification No.: 02134 Rev. 5/13
BEI Sensors
PHD
Programmable Hall Device
Product Specifications
Box Dimensions: 6.30 x 4.92 x 2.03”
Power Requirements: 120V AC
PHD Package includes: PHD programming
box, AC adapter, North American power cord,
USB computer interface cable, USB flash
drive(contains PHD programming software,
user manual, and data sheet).
BEI Sensors introduces the Programmable Hall Device (PHD), an easy way to
take control of customizing BEI Hall effect sensor output. This compact system
interfaces with your PC to BEI Hall effect sensors and provides users with the
ability to create output functions that meet specific requirements. The system
includes proprietary PHD software (compatible with Windows XP, 7 or Vista),
the PHD programming unit, power cord and a USB computer interface cable.
Cables to interface the PHD to specific sensor connectors are sold separately. A
positions fixture is recommended if the sensors are not programmed after
installation in the final assembly
After installing the PHD software, connect the PHD programmer to the sensor
and PC and you’re ready to program. The PHD software makes programming
simple by providing users an easy to understand screen where programming
routines can be created, stored and recalled for later use. The PHD software
also offers a real-time graphical representation of the sensor output allowing
verification of the sensor’s functionality after programming. The PHD can be
used to program both the analog and PWM output versions of BEI
programmable Hall effect sensors. BEI Sensors can also work with you to
provide adaptations to the PHD system that you may need.
Product Features
• For use on programmable BEI Hall Effect Sensor Series
9360, 8360 and 9960
• Sensors can be programmed after installation into an
assembly reducing errors from mechanical tolerances
• Multi-point programming increases sensor accuracy
• Ability to program binary/switch output
• Independent programming of outputs in dual output sensors
• Program electrical angle anywhere within the mechanical
rotation of the sensor
• Set high and low clipping points on output
• Create, name and store program routines for later use
• Ability to reprogram sensor or lock the sensor to prevent
accidental reprogramming
• Real-time verification of programmed output
Program Interface
System Requirements
Operating System: XP, Vista, or Windows 7
(32 or 64 bit)
Computer Memory: 512 MB
Screen Resolution: 1024x768 pixels
AC Power 120/240 VAC, 50/60 Hz
Home Screen
View Output
Screen
Ordering Information
PHD System Part Number: PHD