BEI Sensors SA100R Rotary Digital Display - Manual

SA100(R) Rotary Digital Display
Construction: 1/16” sheet metal
Dimensions: Height: 2.835”, Width: 5.878”,
Depth: 2.756”, Weight: 1.07 lbs
Operating Voltage: 12-27 VDC ±10%
(power supply 60012-003 included)
Maximum Power Consumption: 6 watts
Maximum Data Rate: 2MHz
Operating Temperature: 0 to 45°C
Storage Temperature: -20 to 60°C
Inputs: Two channels in quadrature. Differential
or single ended (user selectable)
Environment: Indoor use, IP20
(subject to change without notice)
Tel: 805-968-0782 /800-350-2727 | Fax: 805-968-3154 / 800-960-2726 | 7230 Hollister Ave., Goleta, CA 93117-2807 | www.beiied.com
Specification No. 924-02102-001 Rev.1-07
This versatile 7-digit display reads out in degrees/minutes/seconds (DMS) or deci-
mal degrees. Resolutions up to 0.001 degree are selectable from the front panel.
The SA100 (R) accepts a 5VDC standard differential quadrature signal from either
linear or rotary incremental encoders. Incremental and absolute operating modes
are available. The SA100(R) also features an auxiliary reference input, allowing inte-
gration of an independent reference marker from a remote switch. The SA100(R)
comes with its own 12VDC power supply which operates on 115 VAC line voltage.
A Setup Mode allows front panel programming of
• automatic calibration
• display resolution
• axis resolution
• count direction
• loss of signal error
• referencing
• angular error
• gear ratio compensation
• table radius factors
BEI P/N 924-60012-005
An optional installation kit is available for the
SA100(R). The kit includes all necessary hard-
ware to mount the SA100(R) into a panel or to
attach an adjustable support for desktop use.
BEI P/N: 31326-001, $25.00
Encoder Input (9-way D)
Pin No. Function
1 N/C (or 0V)
2 Channel A
3 Channel /A
4 Channel B
5 Channel /B
6 0V
7 +5V
8 Channel Z
9 Channel /Z
Technical Specifications
Mounting Kit (Optional)
Panel
Mounting
Encoder
Input
(9 pin
D type
connector)
Encoder- Type
selector switches
Cable
retaining
clamp
2.5mm power inlet
(12-27 VDC ± 10%)
Auxiliary Input
Differential
Encoder
Single Ended
Encoder
ON ON
Desktop or Support
Mounting Arm