Datamax-O'Neil E-Class Mark III 3xxxxxxx Operator’s Manual - Manual (Page 37)

Chapter 4 – Maintenance and Adjustments 31
4 4 4 . . . 4 4 4 A A A d d d j j j u u u s s s t t t a a a b b b l l l e e e M M M e e e d d d i i i a a a S S S e e e n n n s s s o o o r r r
The optional Adjustable Media Sensor (AMS) allows the printer to accept a wider variety of media
configurations. The table below defines general AMS positions for various media and Top of Form (TOF) types.
AMS Positioning
Media Type Sensor Location TOF Sensing Method
Continuous Center of the Media Continuous
Die-Cut Center of the Label
Gap
Notched Center of the Notch
Reflective Center of the Mark Reflective
Position the AMS as follows:
1) On the Bottom AMS Sensor, identify the proper Indicator for
use with your media.
 Gap or Notch Indicator
 Reflective (Mark) Indicator
2) Slide the Bottom AMS sensor so the Indicator is in line with the center of the notch, gap, or
reflective (mark) of the installed media.
3) Slide the Top AMS Sensor over to the same setting as the Bottom AMS Sensor, (this is not
necessary if using reflective media).
312
 Bottom AMS Sensor
 Top AMS Sensor
4) Load media, see Section 2.3.