Draw-Tite 65024 FRONT MOUNT RECEIVER - Manual

Frame
Rail
Enlarge Holes
FIGURE 1
Frame Rail
Bumper Fascia
Front Mounted Receiver
Installation Instructions
Ford Ranger
Mazda B-Series Trucks
Part Numbers:
65024
1. If present lower plastic radiator shield or skid plate.
2. Enlarge six (6) existing holes in frame rails as shown in Figure 1.
3. Feed blocks and carriage bolts through access hole into position using pull wire.
4. Raise receiver into position and install conical washers and hex nuts. See Figure 1.
5. Check clearance of transmission cooler line. Bend or tie back to prevent contact with receiver as shown in Figure 2.
Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Rev. A 11-07-05 N65024 Sheet 1 of 3 z 2005 Cequent Towing Products
Conical Washer, 1/2” Qty. (6) 3
Pull Wire, 1/2” Qty. (2) 5 Spacer, 1” x 2” x 1/4” Qty. (6) 2
Hex Nut, 1/2” Qty. (6) 4 Carriage Bolt, 1/2”-13 x 1-3/4” Qty. (6) 1
Equipment Required:
Wrenches: 8mm, 10mm,
12mm, 7/8”
Drill Bits: 1/2”
Fastener Kit: F65024
Radiator
Check
Clearance
Crosstube
Transmission
Cooler Line
FIGURE 2
Receiver Shown In Proper Position
Hitch Requires 5/8” Pin and Clip
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. A hitch or ball which has been damaged should be removed and replaced.
Observe safety precautions when working beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch. Do not cut, weld, or
modify hitch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
CARGO CAPACITY – DO NOT EXCEED
500 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000