Draw-Tite 65009 FRONT MOUNT RECEIVER - Manual

Front Mounted Receiver
Installation Instructions
Jeep Cherokee, Comanche,
Wagoneer (Downsize)
Part Numbers:
65009
1. If present, remove steel skid shield and return to vehicle owner.
2. Remove lower fascia or trim to clear receiver. CONSULT VEHICLE OWNER BEFORE TRIMMING.
3. Lower swaybar bracket on each frame rail.
4. Raise hitch into position and loosely reinstall swaybar bracket as shown above. NOTE: The lip on the underside of the frame rail may need
to be flattened so block can be installed.
5. Using the receiver as a template drill a 1/2” hole as shown above.
6. Feed the remaining fasteners as shown above through slot in the end of the frame rails using pull wire.
Tighten all 1/2” GR5 fasteners with torque wrench to 75 Lb.-Ft (102 N-m).
Rev. A 11-07-05 N65009 Sheet 1 of 3 z 2005 Cequent Towing Products
Spacer, 1” x 2” x 7/16” Qty. (2) 5
Pull Wire Qty. (2) 9 Spacer, 1-1/2” x 2” x 1/4” Qty. (2) 4
Hex Nut, 1/2” Qty. (2) 8 Carriage Bolt, 1/2”-13 x 2-1/4” Qty. (2) 3
Lock Washer, 1/2” Qty. (2) 7 Conical Washer, 3/8” Qty. (4) 2
Flat Washer, 1/2” Qty. (2) 6 Hex Bolt, M10 x 1.50 x 35 Qty. (4) 1
Tighten all M10 CL10.9 fasteners with torque wrench to 42 Lb.-Ft (57 N-m).
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Wrenches: 15mm, 7/8”
Equipment Required:
Drill Bits: 1/2”
Hammer
Fastener Kit: K65009
CARGO CAPACITY – DO NOT EXCEED
300 LB. OR VEHICLE FRONT GROSS
AXLE WEIGHT RATING. (GAWR)
LB. MAX. WINCH LINE PULL 9000
Receiver Shown In Proper Position
Bumper
Lower
Fascia
Swaybar Bracket
Existing Weldnuts
Drilled Hole
Recovery
Eye
Lip
Frame Rail
Slot