Draw-Tite 41521 MAX-E-LOADER RECEIVER - Manual

ABOVE, EACH SIDE.
2. RAISE HITCH INTO POSITION AND FASTEN WITH CONICAL TOOTHED WASHERS AND NUTS AS SHOWN
AS SHOWN ABOVE, EACH SIDE.
1. INSERT CARRIAGE BOLTS AND BLOCKS THROUGH EXISTING ACCESS SLOTS AND INTO ATTACHMENT HOLES
PROPER POSITION
HITCH SHOWN INSTALLED IN
(TIGHTEN ALL FASTENERS WITH TORQUE WRENCH)
EQUIPMENT REQUIRED:
SYSTEMS OF THE STATE OF NEW YORK AND V.E.S.C. REGULATION V-5.
THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATIONS AND REQUIREMENTS FOR CONNECTING DEVICES AND TOWING
NO DRILLING
FRAME
WRENCHES:
DRILL BITS:
EXISTING ACCESS SLOTS
CONICAL TOOTHED WASHER
1/4 X 1-1/2 X 2 BLOCK (1540)
1/2-13 X 1-3/4 GR5 CARRIAGE BOLT
NUT
BUMPER
7/8
GM FULL SIZE VAN 41521
600
1000
MAX TONGUE
WT(LB)
TOWING VEHICLE MFR'S RATINGS OR
DO NOT EXCEED LOWER OF
HITCH TYPE
WEIGHT DISTRIBUTING
WEIGHT CARRYING
BALL MOUNT
TRLR WT(LB)
6000
10,000
MAX GROSS
CONICAL TOOTHED WASHER
1/4 X 1-1/2 X 3 BLOCK (1171)
1/2-13 X 1-3/4 GR5 CARRIAGE BOLT
NUT
TIGHTEN 1/2 GR5 FASTENERS TO 75 LB.-FT.
WIRING ACCESS LOCATION: SUV3, SUV4
OPTIONAL LOCKING STABILIZING PIN
(Order Separately)
J-PIN
HITCH REQUIRES 5/8" PIN AND CLIP IF STABILIZING PIN IS NOT INSTALLED.
NOTE:Check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is
removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A
hitch or ball which has been damaged should be removed and replaced. Observe safety precautions
when working beneath a vehicle and wear eye protection. Follow car maker's specs for maximum trailer
weight and tongue weight. Do not cut access or attachment holes with a torch.
APPROX WEIGHT (LB.)
when working beneath a vehicle and wear eye protection. Follow car maker's specs for maximum trailer
hitch or ball which has been damaged should be removed and replaced. Observe safety precautions
removed, plug all holes in trunk pan or other body panels to prevent entry of water and exhaust fumes. A
Check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is
weight and tongue weight. Do not cut access or attachment holes with a torch.
NOTE:
APPROX WEIGHT (LB.)
VEHICLE HITCH NO.
2002 Towing Products
1 1 11/15/07
SHEET OF c
42
INSTALLATION INSTRUCTIONS
FASTENER KIT
1130-945
THIS PRODUCT COMPLIES WITH SAFETY SPECIFICATIONS AND REQUIREMENTS FOR CONNECTING DEVICES AND TOWING
SYSTEMS OF THE STATE OF NEW YORK AND V.E.S.C. REGULATION V-5.
Plymouth, Michigan
82580